TD50 Tower Eurotruss

The heavy duty 50cm (20,08in) for ground supported MT, TT, XT, FT100 and Roofs

Heavy Duty – for all Trusses
Eurotruss adds to the existing TD35 and TD44, the TD50 Tower System.
The TD50 Tower is designed for extreme heights and high loads. The TD50 Tower System in combination with MT / TT / XT can go up 20 meters (65,52ft) and handles 8000kg (17637lbs). The TD50 Tower is the standard Tower System for the new MT Roof.

Top Section:
A two Ton double chain hoist Top Part with 4 wheels for high load bearing.
The Top Part has integrated pick up points for »dead hanging«.

Tower Truss:
The mast sections have dimensions of 510x510mm (20,08x20,08in. The main tube is 60x 5mm (2,36 x 0,2in) and the braces are 30x3 mm (1,18 x 0,12in).
One side has additional ladder braces (40mm /1,57in) for easy and safe climbing.

Hinge Set:
A strong and cost effective solution to erect the TD50 Tower.
The hinge sets are half connectors with a hinge fork which allow high vertical load. 4 Hinges are required per tower.

Sleeve Block:
The sleeve block is a fixed MT Block or a TT / XT Corner Block with usage of 2 bolted sleeve plates.
These blocks make it possible to fit the TT/XT/FT100 Truss to all 4 sides by using bolted receivers. The upper plate is equip- ped with an integrated pick up point.

Base System:
A Steel Base on wheels with short or long outriggers in combination with stabilizer bars.

Outriggers:
Available Outriggers for TD50 Base:

OUTR-S03
Short Outrigger

OUTR-L03
Long Outrigger

STAB-03
Stabilizer Bar
for Long Outrigger

 
 
 
 
 
 
 
 
 
 
 
 
 
 
 

TECHNICAL SPECIFICATIONS

Max. Höhe
20m/65,62ft
Max. Gewicht
8000 kg / 17.637 lbs
TD50
Verbindungsblock
MT, TT, XT and FT100
Eigengewicht
Datenblatt PDF